1999 Ski-Doo Factory Shop Manual Volume Two, Page 363Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
MATERIAL REPAIR PROCEDURE
Fiberglass
This material is repairable and repaintable, using any one of several kits available on the market
R.I.MUrethane
R.I.Murethane is light colored (tan) on the inside with smooth surface-
WARNING
Material should be repaired and repainted in well-ventilated area only
Heat the surface with heater lamp placed at 38 cm (15 in) for period of 15 minutes Sand the surface using smooth dry sand paper Use the same product if final finish is required Clean surface with Crest Hi-Solv product Apply flexible primer such as Crest Prima Flex stock noAP-F Wait 10 minutes Repaint (air dry during 72 hours (approximately))