1999 Ski-Doo Factory Shop Manual Volume Two, Page 347Get this manual
Section 08
STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
Make sure the vehicle is leveled by placing an angle finder under the main frame member as shown on the following illustration
NOTE: The reference point must be the same relative to each side
A06G05A
1Angle finder
Using special tool (PN 529 021 600) mounted to the ski leg, position the angle finder on the tool as shown in the following illustrationAn alternative location for the angle finder, if the special tool is not available, is the outside of the ski leg housingAdjust the camber to 0.5
A06G07A
CAUTION
TYPICAL 1Equal distance on each side 2Same reference point (rivet)
Angle finder must sit square against swing armPositioning angle finder against weld bead or decal may result in false reading529 021 600
Adjustment is performed by adjusting length of left and right tie rods no20