1999 Ski-Doo Factory Shop Manual Volume Two, Page 293Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
NOTE: Stop switches include the ignition switch, the tether cord switch and the emergency cut-out switchIt is important to take note that voltage measurements must be taken while starting the vehicle using the manual starterVoltages obtained upon starting are proportional to the force applied onto the manual starterA low voltage is therefore normal under low cranking forcePerform testing in the prescribed order and replace any parts not performing according to specificationsIt is important to resume all tests when replacing componentIf not specified, the probe connecting sequence is not importantLIGHTING SYSTEM TESTING (S-Series liquid cooled models and Skandic WT LC) PART Lighting generator coil TEST TO BE PERFORMED Power WIRE COLOR YL and YL YL and engine Insulation YL and engine
M: Male F: Female