1999 Ski-Doo Factory Shop Manual Volume Two, Page 291Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
1Disconnect housing from engine (YELLOW, YELLOW and BLACK wires)2Connect multimeter probes to YELLOW wires,then place selector switch to and scale to VAC0.00 3Activate the manual starter and check values indicated by the multimeter4Repeat operation times
A05E0DA
6Compare readings with those appearing in the IGNITION table
CONCLUSION
If none of the above testing operations produced valid results, it is strongly recommended to keep on testing according to the list appearing in the Resistance column of the IGNITION tableSet the multimeter as indicated