1999 Ski-Doo Factory Shop Manual Volume Two, Page 180Get this manual
Section 04 ENGINE Subsection 11 (CARBURETOR AND FUEL PUMP)
NOTE: Make sure that throttle cable does not hold throttle slideLoosen cable adjuster accordinglyThrottle cable adjustment will be done during adjustment of throttle-slide-to-cover free playFinal idle speed adjustment (engine running at idle speed) should be within 12 turn of idle speed screw from preliminary adjustmentMODELS MX 440 MX 500 MX 670 HO Formula 500DLX 500 Formula 583DLX 583 Formula 670DLX 670 Summit 500 Summit 670 Grand Touring 500 Grand Touring 583 Skandic WT Skandic SWT Skandic WT LC THROTTLE SLIDE HEIGHT mm (in) 1.5 (.059) 1.8 (.071) 1.9 (.075) 1.8 (.071) 2.0 (.078) 2.1 (.083) 2.2 (.087) 2.4 (.094) 1.8 (.071) 2.0 (.078) 1.5 (.059) 1.3 (.051) 1.5 (.059)
INSTALLATION
CAUTION
Never allow throttle slide(s) to snap shutPrior to install carburetor, adjust air screw and preliminary idle speed as described aboveTo install carburetor on engine, inverse removal procedureHowever, pay attention to the following: On applicable models, make sure to align tab of carburetor and air intake silencer (if applicable) with notch of adaptor(s)On applicable models, install adaptor with UP mark facing up