1999 Ski-Doo Factory Shop Manual Volume Two, Page 148Get this manual
Subsection 06
Section 04 ENGINE (OIL INJECTION SYSTEM)
CHECKING OPERATION
Oil Pump
On Vehicle NOTE: Main oil line must be full of oilSee bleeding procedure aboveLift rear of vehicle and support with mechanical standUnbolt banjo fittings from pumpStart engine and stop it as soon as it firesCheck that oil level in small oil lines is passed banjo fittings end by about 25 mm (1 in) (this will be indicated by clear section of small oil lines of about 25 mm (1 in))Repeat the procedure until this condition is attainedReconnect banjo fittings with washers on each side, start engine and run at idle while holding the pump lever in fully open positionOil columns must advance into small oil linesA15C2DA
1Small oil line 2Marks aligned 3Main oil line
Reinstall all parts except air silencerBleed the small oil line between pump and intake manifold by running engine at idle while holding the pump lever in fully open positionNOTE: If the air silencer has been reinstalled, make hook out of mechanical wire to lift the lever