1999 Ski-Doo Factory Shop Manual Volume Three, Page 270Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
WINDSHIELD INSTALLATION
Remove protective filmPosition the windshield on the hood then push it down until the tabs are fully inserted into the hood slotsLock the windshield tabs in position
All Models Except Grand Touring 700SE Unfasten speedometer cable from angle driveRemove clips holding speedometer cable to bottom panA30E05A
1Locking ring
CAUTION
Never touch glass portion of an halogen bulb with bare fingers, as it shortens its operating lifeIf by mistake glass is touched, clean it with isopropyl alcohol which will not leave film on the bulb
Taillight
If the taillight bulb is burnt, expose the bulb by removing red plastic lensTo remove, unscrew the retaining screwsVerify all lights after replacementA30H16A