1999 Ski-Doo Factory Shop Manual Volume Three, Page 263Get this manual
Section 08
STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
Using special tool (PN 529 021 600) mounted to the ski leg, position the angle finder on the tool as shown in the following illustrationAn alternate location for the angle finder if the special tool is not available is the outside of the ski leg housing-
CAUTION
Angle finder must sit square against swing armPositioning angle finder against weld bead or decal may result in false reading529 021 600
K-D Tools
No2968 ANGLE FINDER
K-D Tools Lancaster, PA 17004
A06G1KA
TYPICAL CAMBER ADJUSTMENT SET-UP