1999 Ski-Doo Factory Shop Manual Volume Three, Page 235Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
NOTE: Stop switches include the ignition switch, and the emergency cut-out switchIt is important to take note that voltage measurements must be taken while starting the vehicle using the manual starterVoltages obtained upon starting are proportional to the force applied onto the manual starterA low voltage is therefore normal under low cranking forcePerform testing in the prescribed order and replace any parts not performing according to specificationsIt is important to resume all tests when replacing componentIf not specified, the probe connecting sequence is not importantLIGHTING SYSTEM TESTING (CK3 Series 360 W) Part Test to be performed Output Coil insulation Wire color YL and YL YL and engine Multimeter probe connection 2-06(A,B,C)-F and 2-06(A,B,C)-F 2-06(A,B,C)-F and engine Resistance Value (Ohms) 00.0 00.5 times 0.L Multimeter scale 00.0 00.0 Voltage Value (Volts) 3.55.5 times Multimeter scale 00.0VAC Note Do the test between and B, and and and CThe term "engine" refers to the engine metal parts connected to the magneto housing