1999 Ski-Doo Factory Shop Manual Volume Three, Page 227Get this manual

1999 Ski-Doo Factory Shop Manual Volume Three, Page 227

Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
5TRIGGER COIL TESTING
All Models

Resistance Testing
1Connect probes to WHITEYELLOW and BLUE YELLOW wires from trigger coil 10-04 housing2Activate the manual starter and check values indicated by the multimeter3Repeat operation times4Compare readings with those appearing in the IGNITION tableA30E0OA

TYPICAL ON-VEHICLE TESTING

If readings do not correspond to the above mentioned indications, replace switchIf none of these verifications are conclusive, the problem finds its source in the main wiring harnessProceed as follows:

Back to 1999 Ski-Doo Factory Shop Manual Volume Three