1999 Ski-Doo Factory Shop Manual Volume Three, Page 188Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
INSPECTION
10, Slider Shoe
Check cam slider shoes for wearReplace when inside edge of cam slider shoe slope base is worn to mm (.039 in) or less
12, Screws
These screws are machined at there endWith the adjustment ring steel to position (zero), screw ends are flush with inner side of fixed pulley half when tighten-
CAUTION
If any of these screws is not flush with inner side of sliding pulley, bushings will worn unequallyAssemble driven pulley components by reversing the disassembly procedure
A15D0OA
Coat cam interior with anti-seize lubricant
1Measure thickness of slope base here 2Sliding pulley side 3Slope base
ASSEMBLY
10, Cam Slider Shoe
When replacing slider shoes, always install new set (3 shoes) to maintain equal pressure on the camInstall slider shoes as per following photoRed slider shoes are being used for reverse and black ones for forward