1999 Ski-Doo Factory Shop Manual Volume Three, Page 183Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
INSPECTION
9,10, Bushings
Check for cracks, scratch and for free movement when assembled to fixed halfUsing dial bore gauge measure bushing diameterMeasuring point must be at least mm (14 in) from bushing edge1 2
A15D0OA
1Measure thickness of slope base here 2Sliding pulley side 3Slope base
ASSEMBLY
6, Cam Slider Shoe
When replacing slider shoes, always install new set (3 shoes) to maintain equal pressure on the camAssemble driven pulley components by reversing the disassembly procedure