1999 Ski-Doo Factory Shop Manual Volume Three, Page 176Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
26,27,28, Calibration Screw, Washer and Locking Nut
When installing calibration screw, make sure to install washer as shownPosition dowel tube split at the illustrated angle30 5
A16D2PA
A16D07A
1Washer
Torque locking nut to 10 Nm (89 lbfin)
Always use the same type of pin as originally installed when servicingDifferent types have different weights for calibration purposeRefer to TECHNICAL DATA 10-03
21,22,23, Ramp, Dowel Tube and Screw
Insert dowel tube from chamfered sideMake sure ramp is centered on dowel tube1