1999 Ski-Doo Factory Shop Manual Volume Three, Page 163Get this manual
Section 04 ENGINE Subsection 08 (CARBURETOR AND FUEL PUMP)
REMOVAL
Install hose pincer (PN 295 000 076) on fuel supply line close to pump inlet
CLEANING AND INSPECTION
The entire pump should be cleaned with general purpose solvent before disassemblyFuel pump components should be cleaned in general purpose solvent and dried with compressed air
295 000 076
WARNING
Solvent with low flash point such as gasoline, naphtha, benzol, etc should not be used as each is flammable and explosiveInspect diaphragmThe pumping area should be free of holes, tears or imperfectionsReplace as needed
A01B2JA
Disconnect fuel outlet line(s)Disconnect impulse lineRemove screws securing fuel pump support to chassis