1999 Ski-Doo Factory Shop Manual Volume Three, Page 153Get this manual
Section 04 ENGINE Subsection 08 (CARBURETOR AND FUEL PUMP)
Air intake silencer must be reinstalled and choke cable properly routed before finalizing adjustmentAdjust choke cable to obtain maximum gap of approximately 0.3 mm (.012 in) between tab and plunger when choke lever is not activatedA06C2IA
1Spacer and spring on PTO side 2Ferrule screw aligned with rod hole 3Dielectric grease
Apply dielectric grease (PN 413 701 700) on cable housing endAll plungers must start to open at the same timeBend ferrule end as requiredDo not change position of ferrule on rodIts screw must remain in line with choke rod hole