1999 Ski-Doo Factory Shop Manual Volume Three, Page 151Get this manual
Section 04 ENGINE Subsection 08 (CARBURETOR AND FUEL PUMP) -
CAUTION
Make sure that tool stopper is properly lean on venturi recessThis will ensure that tool tip is properly seated under choke plunger, as shown on the next photosNOTE: Choke plunger tool can be used both sides depending on carburetor typeUse larger diameter for Mikuni 38 mm and smaller diameter for Mikuni 34 mm
A06C0LA
TYPICAL FULL THROTTLE POSITION 1Free play between stop screw and its stopper