1999 Ski-Doo Factory Shop Manual Volume Three, Page 137Get this manual
Section 04 ENGINE Subsection 07 (REWIND STARTER)
REMOVAL
Using small screwdriver, extract rope knot from starter grip no13Cut rope close to knotTie knot near starterRemove screws no3 and washers no2 securing rewind starter no1 to engine then remove rewind starterDISASSEMBLY
To remove rope from rewind starter mechanism: First remove locking ring no12, locking spring no11, circlip no10, pawl lock no9 and pawl no8 Remove sheave no5 from starter housing no1 Disengage key no7 and pull out rope no6
A01C13A
1Outer end into guide notch
NOTE: Due to dust accumulation, rewind starter must be periodically cleaned, inspected and relubricated-
CAUTION
It is of the utmost importance that the rewind starter spring(s) be lubricated periodically using specific lubricantsOtherwise, rewind starter component life will be shortened andor rewind starter will not operate properly under very cold temperaturesLubricate spring assembly with silicone compound grease (PN 420 897 061) and position into starter housing as illustrated