1999 Ski-Doo Factory Shop Manual Volume One, Page 308Get this manual
Section 07 REAR SUSPENSION Subsection 03 (SC-10 SPORT AND TOURING SUSPENSIONS)
Close and lock barAdjust handle horizontal by changing position of clevis pinPush down on handle until il locksRemove spring stopper and cap then release handleAt installation, cap opening must be 180 from spring stopper opening
INSPECTION
Shock Absorber
Refer to SUSPENSION AND SKI SYSTEM 08-03 then look for Shock Inspection
17, Slider Shoe
Measure slider shoes from the bottom to the 0.5 mm (.020 in) radius as shown on the next photoMinimum thickness must be mm (.080 in)
A03F12A
1Spring stopper opening 2Cap opening
20, Stopper Strap
Inspect strap for wear or cracks, bolt and nut for tightnessIf loose, inspect hole for deformationReplace as requiredMake sure it is attached through the 2nd hole from the endTorque nut to 11 Nm (97 lbfin)A 1