1999 Ski-Doo Factory Shop Manual Volume One, Page 307Get this manual
Subsection 03
Section 07 REAR SUSPENSION (SC-10 SPORT AND TOURING SUSPENSIONS)
NOTE: To prevent cross shaft from turning when unscrewing screws assembled with threadlocker, proceed as follows: Knock on screw head andor heat to break threadlocker bond Loosen screw then retighten Remove the opposite screw Remove the first one
Unscrew center idler wheel axle from tunnel then removeLift rear of vehicle until spacers, idler wheels, washers and springs can be removed
A03F13A
1Stroke limiter on rear side
8,9, Pivot Arm and Flat Washer
At installation pivot arm grease fitting must face rearwardSmall washer must be against nutLarge washers must be inside rails on both sides
10, Outer Bushing
At installation, hole must face adjustment screw1