1999 Ski-Doo Factory Shop Manual Volume One, Page 211Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
Compress outer cam using spring compressor (PN 529 035 524)Install spacer no2 then secure outer cam with half keys no1, as shown in the next photo-
CAUTION
Ensure that half keys are properly inserted into shaft groove and that spacer recess is facing half keys1
A30D0HA
TYPICAL 1Spacer 2Shoulder on this side
Should installation procedure be required, refer to BRAKE 05-06 then look for Brake Disc and Countershaft Bearing AdjustmentReinstall the pulley on the countershaft by reversing the removal procedure
1, Pulley Retaining Screw
Torque to 25 Nm (18 lbfft)A03D3JA
1Half keys inserted into shaft groove 2Spacer recess facing half keys