1999 Ski-Doo Factory Shop Manual Volume One, Page 210Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
Install support plate included in tool (PN 529 031 100) inside sliding halfPlace extractor (PN 529 035 575) below bushing2 1
A03D2SA
A03D1WB
1BLACK slider shoe 2RED slider shoe
TYPICAL 1Support plate 2Extractor
Assemble driven pulley components by reversing the disassembly procedure
Mount screw head of new puller (PN 529 035 524) in viseTurn pulley half by hand to extract old bushingBefore bushing installation, file sliding half bore to remove burrs from crimping areasCoat bushing outside diameter with Loctite 609 (PN 413 703 100)Place new bushing on sliding half and slightly tap to engage squarely the bushing in the sliding