1999 Ski-Doo Factory Shop Manual Volume One, Page 203Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
REMOVAL
Remove belt guard and drive belt from vehicleRemove the cap screw no13, lock washer no12, washer no11, extension no17 and shims no16 then pull the driven pulley from the countershaft
Remove snap ring no2 to disassemble the outer cam and the pulley halves;CLEANING
WARNING
Driven pulley cam is spring loaded, use above mentioned tool
14, Countershaft
Should countershaft no14 removal be required, refer to BRAKE 05-06 then look for Countershaft and Brake Disc Removal
6,7, Large Bushing and Small Bushing
During break-in period (about 10 hours of use), teflon from bushing moves to cam or shaft surfaceA teflon over teflon running condition occurs, leading to low frictionSo it is normal to see gray teflon deposit on cam or shaftDo not remove that deposit, it is not dustWhen dust deposit has to be removed from the cam or the shaft, use dry cloth to avoid removing transferred teflon