1999 Ski-Doo Factory Shop Manual Volume One, Page 195Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
A07E0CA A25F0DA
TYPICAL 1A ramp facing upwards 2Welding clamp
TYPICAL 1Belt flush with the top of the pulley halves
INSTALLATION
Driven Pulley and Chaincase
Install new upper chaincase oil seal and new chaincase cover sealReinstall the driven pulley on vehicle by reversing the removal procedureNOTE: If chaincase screws have been loosened, chaincase can be reinstalled to its initial position by securing driven pulley support before tightening chaincase retaining screwsMake sure to install alignment shims as noted at removal