1999 Ski-Doo Factory Shop Manual Volume One, Page 161Get this manual
Subsection 09
Section 04 ENGINE (CARBURETOR AND FUEL PUMP)
Hook throttle cable into the needle retainer plateNOTE: Do not obstruct hole in throttle slide when installing needle retaining plateThis is important to allow air escaping through and thus allowing quick response1 2
CARBURETOR ADJUSTMENTS
Adjustments should be performed following this sequence: air screw adjustment throttle slide height (preliminary idle speed adjustment) throttle cable adjustment carburetor synchronization (dual carburetor models) final idle speed adjustment (engine running) oil pump with carburetor synchronization
A00C1TA
CENTER POST TYPE 1Throttle cable 2Needle retaining plate 3Throttle slide
Make sure the nylon packing no4 is installed on all applicable throttle slides
A02C09A