1999 Ski-Doo Factory Shop Manual Volume One, Page 154Get this manual
Section 04 ENGINE Subsection 08 (REWIND STARTER)
REMOVAL
Using small screwdriver, extract rope knot from starter grip no15Cut rope close to knotTie knot near starter
ASSEMBLY
At assembly, position spring no4 outer end into spring guide notch then wind the spring counterclockwise into guide
Tundra Series Slightly lift cylinder cowlRemove screws no3, lock washer, washer no2 and clipRemove fan cowl that contains rewind starterS-Series Remove screws no3 and washers no2 securing rewind starter no1 to engine then remove rewind starterAll Models Remove pump from rewind starter cover;
WARNING
Since the spring is tightly wound inside the guide it may fly out when rewind is handledAlways handle with care
DISASSEMBLY
To remove rope from rewind starter mechanism: First remove locking ring no12, locking spring no11, circlip no10, pawl lock no9 and pawl no8 Remove sheave no5 from starter housing no1 Disengage key no7 and pull out rope no6