1999 Ski-Doo Factory Shop Manual Volume One, Page 12Get this manual
INTRODUCTION
TYPICAL PAGE
Section 05 TRANSMISSION Subsection 03 (DRIVEN PULLEY)
Turn puller handle and sliding half at once to extract the bushing
INSTALLATION
Countershaft
Title indicates main procedure to be carried-outItalic bold face type setting indicates particular procedure concerning modelItalic bold face setting in this case indicates that particular procedure for and S-Series is finished, so from this point, all models are concerned"TYPICAL" caption indicates general view which does not represent full detail"TOP VIEW" caption helps you in understanding illustrationCall-outs for above illustration
CAUTION
529 031 300
Always apply anti-seize lubricant (PN 413 701 000) on the countershaft before final pulley installation
F-Series and S-Series Only
529 031 200
Should installation procedure be required, refer to BRAKE 05-05 then look for Brake Disc and Countershaft Bearing AdjustmentReinstall the pulley on the countershaft by reversing the removal procedure
A03D1YA
All Models