1997 Ski-Doo Factory Shop Manual Volume Two, Page 301Get this manual
Section 08 BODYFRAME Sub-Section 02 (BODY)
To remove decal; heat old decal with heat gun and peel off slowlyUsing isopropyl alcohol, clean the surface and dry thoroughlyApply liquid soap to new decal and carefully position the decalUsing sponge or squeegee, remove the air bubbles and surplus water working from the center toward the edgesAllow to air dry2
CAUTION
A03H17A
Do not apply isopropyl alcohol or solvent directly on decals
WINDSHIELD INSTALLATION
When peeling off the protective film some polyethylene particles may remain on the windshieldA soft clean cloth moistened with naphtha (camping equipment fuel) will easily remove the remaining particles
S-SERIES 1Latch 2Temporary remove headlamp molding for windshield installation