1997 Ski-Doo Factory Shop Manual Volume Two, Page 286Get this manual
Section 07 STEERINGFRONT SUSPENSION Sub-Section 02 (STEERING SYSTEM) A B
WARNING
Never lengthen tie rod so that threaded portion of ball joint exceeds 20 mm (2532 in)
A01G04A
CAMBER: specific inward or outward tilt angle of ski leg compared to vertical line when viewing the vehicle from frontThis angle is adjustable on some models onlyA06G04A
Adjustments
S-Series Adjustments should be performed following this sequence: Pivot arm centering Set camber angle (some models) Check for horizontal handlebar Set toe-out
1Tie rod no14 2Center of pivot arm in line with bolt end
DSA System
PIVOT ARM CENTERING