1997 Ski-Doo Factory Shop Manual Volume Two, Page 283Get this manual
Section 07 STEERINGFRONT SUSPENSION Sub-Section 02 (STEERING SYSTEM)
To install, stick the heating element to the handlebar making sure the wires do not interfere with operation of the accelerator or brake handle
For proper torque specifications refer to the specific exploded view for the vehicle being serviced1 2
WARNING
Never use lubricants (e.gsoap, only grease, etc to install the handlebar grip, use mix of soap and waterMix 40 parts of water with one part of dish washing soap (recommended: Ultra Joy, Sunlight or Palmolive)Heat the grip with heater gun or spot light to ease installationInsert new grip with rubber mallet
A02G0IA
INSPECTION
Refer to TESTING PROCEDURE 05-07
TYPICAL 1Parallel with steering arm 2Steering arm
10,16, Ball Joint (Left Hand and Right Hand Threads)
Inspect ball joint ends for wear or looseness, if excessive, replace themScrew threaded end of the ball joint into the tie rodThe maximum external threaded length not engaged in the tie rod must not exceed the value in the following thread length chart: