1997 Ski-Doo Factory Shop Manual Volume Two, Page 276Get this manual
Section 06 REAR SUSPENSION Sub-Section 05 (TRACK)
TRACK TYPE APPLICATION
Refer to TECHNICAL DATA section 09-03 RH drive axle end bearing angle drive and square pin Move transmission sidewayDo not remove brake mechanism nor driven pulleyRefer to SKANDIC WT SUSPENSION 06-03Remove drive axle then track
GENERAL
This section gives guidelines for track removalSome components require more detailed disassembly proceduresIn these particular cases, refer to the pertaining section in this manual
INSTALLATION
All Models Reverse the removal procedureNOTE: When installing the track, respect rotation direction indicated by an arrow on track threadCheck sprockettrack alignment as described in DRIVE AXLE 06-04
INSPECTION
Visually inspect track for: cuts and abnormal wear broken rods broken or missing track cleats If track is damaged or rods are broken, replace trackFor damaged or missing cleats, replace by new ones, using cleat remover (PN 529 0287 00)Use small-cleat installer (PN 529 0085 00)'