1997 Ski-Doo Factory Shop Manual Volume Two, Page 270Get this manual
Section 06 REAR SUSPENSION Sub-Section 04 (DRIVE AXLE)
9,13, Sprocket and Half-Sprocket
To remove press fit sprockets, use press and suitable support as illustrated
S-Series
A00F06A
A06D1XA
TYPICAL 1Support sprocket near hub
' press fit can be foundEnsure to replace ring reinforced sprockets with the same typeASSEMBLY
8,9,13, Drive Axle and Sprocket
To assemble press fit sprockets, use press and suitable pipe as illustratedSprockets must be assembled according to the following dimensions