1997 Ski-Doo Factory Shop Manual Volume Two, Page 260Get this manual
Sub-Section 02
Section 06 REAR SUSPENSION (SC-10 SUSPENSIONS (ALL VERSIONS))
Slowly push piston into damper bodySlight up and down movement may be required to allow all air to pass through piston assemblyNOTE: Fast installation of the damper rod may displace the floating piston from its original positionThis must not occur if the damper is expected to perform as designedWith damper rod piston into oil volume, re-top damper oil volumeOil level should be to damper body thread baseSeal carrier assembly can now be threaded into damper bodyThis should be done slowly to allow weapage of shock oil from body while installing'
A06F15A
' next step
NOTE: Reinstall Schrader valve core before
Install damper rod assembly into the damper bodyLightly oil damper piston seal ring with shock oil to ease installation