1997 Ski-Doo Factory Shop Manual Volume Two, Page 249Get this manual
Section 06 REAR SUSPENSION Sub-Section 02 (SC-10 SUSPENSIONS (ALL VERSIONS))
COMPONENT REMOVAL AND INSTALLATION
Lift rear of vehicle and support it off the ground
21, Rear Axle
Completely loosen track tensionUnscrew one rear idler wheel screwPull out rear axle from opposite side of offset inner wheelProceed on either sides for models with wheels on rear axleAt assembly, temporary loosen rear shackle lower pivot nut and ACM (Acceleration and Control Modulator) support rear boltAlign spacer hole with adjusting bolt
A03F2DA
1Block ass'y Allen screw 2Schackle
Unscrew block ass'y Allen screws
A03F1LA
TYPICAL