1997 Ski-Doo Factory Shop Manual Volume Two, Page 223Get this manual
Section 05 ELECTRICAL Sub-Section 06 (ELECTRIC STARTER)
STARTER REMOVAL
Disconnect BLACK cable ground connection from batteryWARNING
Always disconnect ground cable first and reconnect lastRemove tuned pipeCut locking tie retaining cable to starter1
F01H0PA
TYPICAL 1Trace indexing marks
Remove starter support nuts then through boltsSeparate end frame from yoke assemblyWithdraw yoke assembly from armatureBrush holder can be removed from end frame by unscrewing nut retaining terminalCheck that the radial play between the armature shaft and end frame is not greater than 0.20 mm (.008 in)Replace end frame if soA29E0AA
6,7,8, Circlip, Spring and Pinion Stop Collar