1997 Ski-Doo Factory Shop Manual Volume Two, Page 152Get this manual
Section 04 TRANSMISSION Sub-Section 03 (DRIVE PULLEY)
9,11,13,14, Screw, Lever Ass'y, Nut and Cotter Pin
Always install lever assemblies so that cotter pins are at the shown sideBesides install cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever
Lift sliding half against spring cover and align spring cover arrow with sliding half mark
WARNING
Whenever replacing centrifugal levers, always replace all at the same timeOtherwise, clutch misbalancing will occur because of levers differenceA16D0DA
Install and torque screws to 13 Nm (115 lbfin)
6,25,29, Sliding Half, Slider Shoe and Governor Cup
To install governor cup, use following tool:
529 0055 00
A16D0BA
1Head on top 2All on the same side