1997 Ski-Doo Factory Shop Manual Volume Two, Page 138Get this manual
Sub-Section 11
Section 03 ENGINE (CARBURETOR AND FUEL PUMP)
REMOVAL
Install hose pincer (PN 529 0099 00) on fuel supply line close to pump inlet
Fuel pump components should be cleaned in general purpose solvent and dried with compressed air
WARNING
529 0099 00
Solvent with low flash point such as gasoline, naphtha, benzol, etc should not be used as each is flammable and explosiveInspect diaphragmThe pumping area should be free of holes, tears or imperfectionsReplace as neededHigh-supply pump with twin outlets: Thoroughly clean filter on top coverReplace pump if too dirty
A01B2JC