1997 Ski-Doo Factory Shop Manual Volume Two, Page 132Get this manual
Sub-Section 11
Section 03 ENGINE (CARBURETOR AND FUEL PUMP)
Throttle slide openings Wide open 34 12 14 18 13,6, 5, 3, 14, 8,
A00C04A
' when installing needle retaining plateThis is important to allow air escaping through and thus
allowing quick response1 2
NOTE: Do not obstruct hole in throttle slide
Close Pilot jet and air screw Throttle slide cutaway Needle taper and needle position Needle jet Main jet
VIEW FROM AIR INTAKE OPENING
' DATA 09 and to SPARK PLUG 05-03NOTE: For high altitude regions, the High AlData Booklet (PN 484 0648titude Technical for binder) gives information 00 and 484 0545 00
about calibration according to altitude and temperature
NOTE: For fine tuning refer to TECHNICAL
A00C1TA
CENTER POST TYPE 1Throttle cable 2Needle retaining plate 3Throttle slide