1997 Ski-Doo Factory Shop Manual Volume Two, Page 100Get this manual
Section 03 ENGINE Sub-Section 05 (CDI SYSTEM)
' done without removing the engine from tenerfastener itthreadlocker bondThison the fas' to break is first necessary to tap will elimichassisCLEANING
Clean all metal components in non-ferrous metal cleanernate the possibility of thread breakageTo remove magneto flywheel no2, install the magneto puller (PN 529 0225 00) Tighten puller bolt and at the same time, tap on bolt head using hammer to release magneto flywheel from its taper
NOTE: The following procedures can be
NOTE: To correctly remove threadlocked