1997 Ski-Doo Factory Shop Manual Volume Three, Page 199Get this manual
Section 08 BODYFRAME Sub-Section 02 (B DY)
To remove decal; heat old decal with heat gun and peel off slowlyUsing isopropyl alcohol, clean the surface and dry thoroughlyApply liquid soap to new decal and carefully position the decalUsing sponge or squeegee, remove the air bubbles and surplus water working from the center toward the edgesAllow to air dry2 1
CAUTION
A06H1N A
Do not apply isopropyl alcohol or solvent directly on decals
At installation, half close hood to install front molding
WIN DSHIELD IN STALLATIO N
When peeling off the protective film some polyethylene particles may remain on the windshieldA soft clean cloth moistened with naphtha (camping equipment fuel) will easily remove the remaining particles
BELT ARD
Disasse bly and Asse bly
N TE: For additional information (ex exploded view) refer to the correspondent parts catalog
Inspection