1997 Ski-Doo Factory Shop Manual Volume Three, Page 195Get this manual
Section 07 STEERINGFRONT SUSPENSION Sub-Section 03 (S SPE SIO and SKI SYSTE M)
1, wing Arm
Lift front of vehicle and support it off the groundRemove cap, circlip then loosen steering arm bolt and pull up steering armNote shim positionsSki leg may fall off from swing armUnbolt lower end of shock from swing armUnbolt radius rod1 3
Check skis and runners for wear, replace as necessaryCheck condition of ski stopperReplace it when deterioratedTo check condition of shock, refer to SC-10 SUSPENSION 06-02 then look for Shock bsorber Inspection
IN STALLATIO N
For assembly, reverse the disassembly procedureHowever, pay attention to the followingApply low temperature grease (PN 413 7061 00) to ski leg componentsTighten nuts and screws to proper torque as mentioned in exploded view
7,8, pper and Lo er Half Arms
Position half arms and tie rods horizontally before tightening nuts
8, djustable Half Arm