1997 Ski-Doo Factory Shop Manual Volume Three, Page 191Get this manual
Section 07 STEERINGFRONT SUSPENSION Sub-Section 02 (STEERIN SYSTE M)
Lengthen the other one by turning it exactly the same amount, so that toe-out is not changed
26, Grease Fittings
Only use low temperature grease (PN 413 7061 00)The following symbols will be used to show what type of lubricant should be used at the suitable locations1 2
WARNING
N ever lengthen tie rod so that threaded portion of ball joint exceeds 20 (2532 in) Close front of skis manually to take all slack from steering mechanismN TE: rubber cord must be hooked in front of skis to keep them closedToe-out is mm (0 in) when skis are in straightahead position and the front of vehicle is lifted off the groundN OTE: To make sure skis are in straight-ahead position, place straight edge against pre-adjusted track and measure the distance between front and rear of skis and straight edgeDistances should be equalAfter the ski toe-out adjustment, distance must be equalTo reduce tolerance when measuring, set one ski to proper toe-out then measure from that ski to the opposite skiA00G01A