1997 Ski-Doo Factory Shop Manual Volume Three, Page 190Get this manual
Section 07 STEERINGFRONT SUSPENSION Sub-Section 02 (STEERIN SYSTE M)
C BER E: On vehicles without adjustable radius arms (no7) the camber is not adjustableN TE: Identical adjustments are required on both sides of the vehicle Make sure the vehicle is leveled by placing an angle finder under the main frame member as shown on the following illustration
Unbolt both upper control arms at ski leg housingTurn tie rod half turn at time to obtain vertical ski leg (0 0.5)Bolt upper control armsH DLEB AR and SKI E-O Check that handlebar is horizontal when skis are in straight ahead position by measuring from the extremities of the grips to the rearmost edge of the tunnel, as shownN TE: The reference point must be the same relative to each sideA06G05A
1Angle finder
Using special tool (PN 529 0216 00) mounted to the ski leg position the angle finder on the tool as shown in the following illustrationAn alternate location for the angle finder if the special tool is not available is the outside of the ski leg housingAdjust the camber to 0.5-