1997 Ski-Doo Factory Shop Manual Volume Three, Page 181Get this manual
Section 06 REAR SUSPENSION Sub-Section 04 (TRACK)
TRACK TYPE APPLICATION
Refer to TECHNICAL DATA section 09-03INSTALLATION
Reverse the removal procedureNOTE: When installing the track, respect rotation direction indicated by an arrow on track threadCheck sprockettrack alignment as described in DRIVE AXLE 06-03
GENERAL
This section gives guidelines for track removalSome components require more detailed disassembly proceduresIn these particular cases, refer to the pertaining section in this manual
Track Tension and Alignment
Track tension and alignment are inter-relatedDo not adjust one without checking the otherTrack tension procedure must be carried out prior to track alignment
INSPECTION
Visually inspect track for: cuts and abnormal wear broken rods broken or missing track cleats If track is damaged or rods are broken, replace trackFor damaged or missing cleats, replace by new ones, using cleat remover (PN 529 0287 00)Use small-cleat installer (PN 529 0085 00)