1997 Ski-Doo Factory Shop Manual Volume Three, Page 176Get this manual
Section 06 REAR SUSPENSION Sub-Section 03 (DRIVE AXLE)
5,12, Bearing
Always push bearing by inner race1 3
A00F0DA
The bearing on the splined side of axle must be pushed until it is seated on shaft shoulderThe end bearing housing bearing must be flush with end of drive axleEach bearing must have its shield facing the sprocketA01D05A
TYPICAL 1Set screw 2Slacken 3Tighten
Extract bearing from its supportWrong chaincase perpendicularity will make it difficult to correctly install the bearing in its support due to the countershaft and support misalignmentA00F05A