1997 Ski-Doo Factory Shop Manual Volume Three, Page 159Get this manual
Section 05 ELECTRICAL Sub-Section 05 (TESTIN PRO CED URE)
M ET TPU (IG NITIO ERA OR OIL)
1Disconnect the 3-wire connector between ignition module and magneto harnessAt installation, secure with new locking ties
1Disconnect wiring harness junction block at engine (the one with YELLOW wires)2Connect tester wires then set switch and dial as follows:
Tester wires Component wires YELLOW wire of magneto harness YELLOW wire of magneto harness Tester switch position Tester dial position
2Connect tester wires then set switch and dial as follows:
Tester wires Component wires WHITE wire of magneto harness BLACKRED wire of magneto harness WHITE wire of magneto harness RED wire of magneto harness Tester switch position Tester dial position