1997 Ski-Doo Factory Shop Manual Volume Three, Page 157Get this manual
Section 05 ELECTRICAL Sub-Section 05 (TESTIN PRO CED URE)
NIPPONDENSO CDI TRIGGER COIL SYSTEM TESTING
Applicable to 599, 699 and 809 Engine Types TE: Ensure ignition cut-out switches are properly working and they are in the ON position prior to performing the following tests
Results:
aIndicator la lights: Trigger coil output is up to specificationsbIndicator la does not light: The problem is faulty trigger coil or bad grounding
WARNING
To pre ve nt erful electric sh ocks hile cranking engine, do not touch neither electro nic ig nitio co nts (ig nitio coil, hig te nsio wire, wire arness, etc or tester leads
IG NITIO OIL TPU T
A paper clip of approximately 20 mm (34 in) will be used as test adapter for the following test1Install the test adapter to spark plug cable close to MAG side spark plug2Connect tester wires then set switch and dial as follows: