1997 Ski-Doo Factory Shop Manual Volume Three, Page 103Get this manual
Section 03 ENGINE Sub-Section 08 (CARBURETOR AND FUEL PUMP)
Set choke lever to close and open positions and ensure that tool properly seats under plunger only when lever is set to fully open positionSet choke lever to close position and, by pulling and pushing choke lever, make sure there is no tension on cable (free play)
A06C2IA
1Spacer and spring on PTO side 2Ferrule screw aligned with rod hole 3Dielectric grease
A01C5JA
CHOKE LEVER CLOSED POSITION
Apply dielectric grease (PN 413 7017 00) on cable housing endAll plungers must start to open at the same timeBend ferrule end as requiredDo not change position of ferrule on rodIts screw must remain in line with choke rod hole
Mach ZZ LT