1997 Ski-Doo Factory Shop Manual Volume Three, Page 102Get this manual
Sub-Section 08
Section 03 ENGINE (CARBURETOR AND FUEL PUMP)
CAUTION
Make sure that tool stopper is properly lean on venturi recessThis will ensure that tool tip is properly seated under choke plunger, as shown on the next photosNOTE: Choke plunger tool can be used both sides depending on carburetor typeUse larger diameter for Mikuni 38 mm and smaller diameter for Mikuni 34 mm
If tool tip does not seat under choke plunger, adjust as follows: Lift up protector cap and loosen choke cable lock nut, as shown in the next photo
A01C5GA
1Lift up protector cap 2Loosen lock nut