1997 Ski-Doo Factory Shop Manual Volume Three, Page 100Get this manual
Sub-Section 08
Section 03 ENGINE (CARBURETOR AND FUEL PUMP)
Throttle Slide Adjustment
All Models Except Mach ZZ LT
WARNING
Ensure the engine is turned OFF, prior to performing the throttle slide adjustmentFor maximum performance, correct carburetor throttle slide adjustment is criticalThe following method should be used with engine turned off: Idle speed screw must be completely unscrewedIt must not contact throttle slideTurn the idle speed screw clockwise until it contacts the throttle slide then continue turning additional turnsRepeat on the other carburetorsThis will ensure identical throttle slide preliminary idle settingRecheck carburetor synchronizationAdjust idle by turning all idle speed screws of the same amount
A01C3MA
THROTTLE LEVER AGAINST HANDLE GRIP 1Throttle cable adjuster 2Throttle slide flush or 1.0 mm (.040 in) lower than carburetor oulet bore (engine side)