1997 Ski-Doo Factory Shop Manual Volume Three, Page 99Get this manual
Section 03 ENGINE Sub-Section 08 (CARBURETOR AND FUEL PUMP)
Check throttle slide position at wide open throttleThrottle slide must be flush or mm (.040 in) lower than carburetor outlet boreAt that same position, check that throttle slide does not contact carburetor coverTurn cable adjuster and recheck synchronization1 2
A06C0JA
1No adjustment on MAG side carburetor 2Locking screws 3Adjusting nut
A01C33A
TYPICAL 1Screw in and out until no cable free play exists 2Check that throttle side does not move 3Idle speed screw completely unscrewed